.:HSTuners::

*AzCivic* · 04-02-2002, 12:32 PM

ok when the piston is at the bottom of the stroke(BDC) that is the 1 in the compression ratio ex. 9:(1) and when it reaches the top of the stroke(TDC) that air is compressed 9 times smaller than it original volume hence the 9 in 9:1 . the higher the compression ratio the more power there is to be had but you'll also risk detonation(the air and gas self igniting at a bad time) which will ruin an engine unless you run race gas which has a higher octane(higher octane= more resistance to detonation).
On the street 11:1 is as high as you want to go, but with a turbo you'll want a 8.5:1 or so compression. Hope this helps.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode

04-02-2002, 12:32 PM	#1
AzCivic Moderator Join Date: Feb 2002 Location: Az Age: 44 Posts: 3,804	ok when the piston is at the bottom of the stroke(BDC) that is the 1 in the compression ratio ex. 9:(1) and when it reaches the top of the stroke(TDC) that air is compressed 9 times smaller than it original volume hence the 9 in 9:1 . the higher the compression ratio the more power there is to be had but you'll also risk detonation(the air and gas self igniting at a bad time) which will ruin an engine unless you run race gas which has a higher octane(higher octane= more resistance to detonation). On the street 11:1 is as high as you want to go, but with a turbo you'll want a 8.5:1 or so compression. Hope this helps.