.:HSTuners::

03-07-2004, 12:39 AM

On a 96 honda accord non vtec, I need to know in my distributor on the icm, which wires are the trigger and 12V wires? Which colors are the wires?

ebpda9 · 03-07-2004, 01:56 AM

read my post in the other thread

03-07-2004, 10:55 AM

Im trying right now to get it working, but i think i have a problem, the rotor is normally pointing to the top left when i open it up, now its pointing to the bottom right, Is my sparkplug configuration not right or something?

ebpda9 · 03-07-2004, 12:33 PM

umm, did u turn the engine ? is it at tdc ?

03-07-2004, 06:26 PM

Yeah man, the tdc is fine, i had this guy look at it hes a mech. He couldnt figure out why my car is not firing up, Heres the problem we need to know on a external coil setup, Where does the red and white wire go? It says for the red a 12v switched source and for the white a signal lead. But im calling the company tommorrow!

03-07-2004, 12:39 AM	#1
luvmy96honda Posts: n/a	icm wiring On a 96 honda accord non vtec, I need to know in my distributor on the icm, which wires are the trigger and 12V wires? Which colors are the wires?

03-07-2004, 01:56 AM	#2
ebpda9 Repost Wagon Join Date: Dec 2001 Location: over here Age: 44 Posts: 17,266	read my post in the other thread __________________

03-07-2004, 10:55 AM	#3
luvmy96honda Posts: n/a	thanks man i appreciate this Im trying right now to get it working, but i think i have a problem, the rotor is normally pointing to the top left when i open it up, now its pointing to the bottom right, Is my sparkplug configuration not right or something?

03-07-2004, 12:33 PM	#4
ebpda9 Repost Wagon Join Date: Dec 2001 Location: over here Age: 44 Posts: 17,266	umm, did u turn the engine ? is it at tdc ? __________________

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

03-07-2004, 06:26 PM	#5
luvmy96honda Posts: n/a	Yeah man, the tdc is fine, i had this guy look at it hes a mech. He couldnt figure out why my car is not firing up, Heres the problem we need to know on a external coil setup, Where does the red and white wire go? It says for the red a 12v switched source and for the white a signal lead. But im calling the company tommorrow!