pc133 running at 100 ??

[Addict]

Originally posted by spoogenet
I've got an Abit BM6 running a Celery 400@500.

The PCI and AGP busses (not sure about ISA) are adjustable as a ratio of the FSB through the BIOS. I believe 3/4, 1/2, 1/3, and 1/4 are my options.

I run the FSB @ 83 MHz vs. the 66 MHz default. PCI is spec'd @ 33 MHz, but I run it at 1/3 of 83 which is a little less than 28 MHz, thus it is underclocked. I can't recall AGP spec, is it 66? I think I may run AGP at 3/4, so 62 MHz. ISA is spec'd at 16 MHz, dunno what that's running.

What you can adjust depends on your MB and the BIOS used. Most manufacturers will put a BIOS that supports whatever the MB is capable of, however it really depends on both hardware and software to function. And this is, of course, assuming you've got a normal consumer board, not an OEM board that system manufacturers like Dell use.

b

Ok. We're on the same page then. That's what I was referring to.