.:HSTuners::

08-02-2002, 09:06 PM

i recently replaced my bumper lights on my 91 accord too. The installation was easier than i thought it would be. From what i can remember, i pulled on the rubber to make it loose around the bumper light. Then there was a clip in which i needed to SLIDE the light out, and finally pulling the other side out slowly. The only attachments made to the bumper lights are the wiring and a plug in the back. Once those are removed, just do the opposite to place them back in. However, when i was placing my last clear light in, the clip wouldnt go back into place. I ended up super glueing all sides of the light onto the car. Might seem cheap, but it's been holding on for almost a month now. If you need more help, simply reply and i'll check my car again.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

08-02-2002, 09:06 PM	#6
accorrdd Posts: n/a	i recently replaced my bumper lights on my 91 accord too. The installation was easier than i thought it would be. From what i can remember, i pulled on the rubber to make it loose around the bumper light. Then there was a clip in which i needed to SLIDE the light out, and finally pulling the other side out slowly. The only attachments made to the bumper lights are the wiring and a plug in the back. Once those are removed, just do the opposite to place them back in. However, when i was placing my last clear light in, the clip wouldnt go back into place. I ended up super glueing all sides of the light onto the car. Might seem cheap, but it's been holding on for almost a month now. If you need more help, simply reply and i'll check my car again.