.:HSTuners::

07-07-2002, 01:46 AM

ues, the emblem is held on with glue, not pins. I just removed my "accord" a couple of months ago. I didn't use a hair dryer because it takes too long to heat. Instead I put my car out in the sun for a little bit and the wire cut right through the glue. If you do it good enough you can get most of the glue off with the wire, just hold it as close to the paint as possible. Removing the remaining glue is the hardest part. Use WD-40 or adhesive remover. Since then I've removed my "LX" and the "eclipse GS" off my GF's 2000 Eclipse.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

07-07-2002, 01:46 AM	#4
accordboy00 Posts: n/a	ues, the emblem is held on with glue, not pins. I just removed my "accord" a couple of months ago. I didn't use a hair dryer because it takes too long to heat. Instead I put my car out in the sun for a little bit and the wire cut right through the glue. If you do it good enough you can get most of the glue off with the wire, just hold it as close to the paint as possible. Removing the remaining glue is the hardest part. Use WD-40 or adhesive remover. Since then I've removed my "LX" and the "eclipse GS" off my GF's 2000 Eclipse.