.:HSTuners::

10-09-2001, 07:47 AM

A very nice setup would be. Headwork done by portflow(port and polish/ 3-5 angle valve job. http://www.portflow.com and some Crower Stage II cams with valve springs and retainers. Also get the head milled .25 and get some type S pistons. Once you get it put back together make sure you have some cam gears and get it dyno tuned. Your car would be making some serious power after that.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

10-09-2001, 07:47 AM	#3
97lude Posts: n/a	A very nice setup would be. Headwork done by portflow(port and polish/ 3-5 angle valve job. http://www.portflow.com and some Crower Stage II cams with valve springs and retainers. Also get the head milled .25 and get some type S pistons. Once you get it put back together make sure you have some cam gears and get it dyno tuned. Your car would be making some serious power after that.