.:HSTuners::

2ndGenTeg · 04-18-2002, 12:55 AM

Here's what I would do:

Camshafts: Toda Spec B/ Jun Stage 2 (Very Similar)
Valvetrain (Valvesprings and Retainers): Toda/Portflow
Cam Gears: Spoon
Port/Polish/Valve Job: Portflow

Some people will tell you to get Ferrea valves, but I think it's a waste of money. You could also het the head milled to increase compression, but I prefer to do that in the piston.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

04-18-2002, 12:55 AM	#2
2ndGenTeg 4th Gear Join Date: Aug 2001 Location: Boulder, CO Age: 45 Posts: 830	Here's what I would do: Camshafts: Toda Spec B/ Jun Stage 2 (Very Similar) Valvetrain (Valvesprings and Retainers): Toda/Portflow Cam Gears: Spoon Port/Polish/Valve Job: Portflow Some people will tell you to get Ferrea valves, but I think it's a waste of money. You could also het the head milled to increase compression, but I prefer to do that in the piston.