.:HSTuners::

04-12-2002, 07:14 AM

Josh
You would have to talk to him. I am probely wrong about a lot of things in this setup. But i do know that he has the cylinder sleves decked at the top. Where the piston his TDC around the piston sleve is sealed. I never knew that this was done for higher compression though i just though it keep the block more stable to handle higher rpms. I do know that he is using rods from some B series engine with ctr or itr pistons. im not really that sure im not great freinds with him but i see him ocasionally and i was'nt really listening when he told me.

next time i see him i will get him to join this fourm and you can ask him about.

Also do you know where i can learn more about displacement, bore, and r/s ratios of b series motors.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode

04-12-2002, 07:14 AM	#1
Integra221 Posts: n/a	Josh You would have to talk to him. I am probely wrong about a lot of things in this setup. But i do know that he has the cylinder sleves decked at the top. Where the piston his TDC around the piston sleve is sealed. I never knew that this was done for higher compression though i just though it keep the block more stable to handle higher rpms. I do know that he is using rods from some B series engine with ctr or itr pistons. im not really that sure im not great freinds with him but i see him ocasionally and i was'nt really listening when he told me. next time i see him i will get him to join this fourm and you can ask him about. Also do you know where i can learn more about displacement, bore, and r/s ratios of b series motors.