.:HSTuners::

2ndGenTeg · 02-22-2002, 06:07 AM

If it were me, here's what I would do:

Bottom end:
Eagle Rods, Arias Pistons (Endyn is great stuff, but I'm anti-Endyn due to personal politics)
Blueprinted, balanced, and knife-edged crank
Bored and Sleeved by Golden Eagle

Head:
Port/Polish by Portflow
Jun Stage 2 or Toda Spec B cams
Matching valvetrain
Spoon Cam Gears

External:
RS Akimoto Short Ram Intake
Bored Throttle Body
Ported/Port Matched Intake Manifold
Fuel System, including high flow fuel rail, injectors, and a fuel pressure regulator
Hytech or SMSP header, Jet Coated
Exhaust- anything but Tanabe

Hondata Standalone

Built and tuned at ImportBuilders- an engine is only as good as the person building and tuning it

Expect 200+ whp

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode

02-22-2002, 06:07 AM	#1
2ndGenTeg 4th Gear Join Date: Aug 2001 Location: Boulder, CO Age: 45 Posts: 830	If it were me, here's what I would do: Bottom end: Eagle Rods, Arias Pistons (Endyn is great stuff, but I'm anti-Endyn due to personal politics) Blueprinted, balanced, and knife-edged crank Bored and Sleeved by Golden Eagle Head: Port/Polish by Portflow Jun Stage 2 or Toda Spec B cams Matching valvetrain Spoon Cam Gears External: RS Akimoto Short Ram Intake Bored Throttle Body Ported/Port Matched Intake Manifold Fuel System, including high flow fuel rail, injectors, and a fuel pressure regulator Hytech or SMSP header, Jet Coated Exhaust- anything but Tanabe Hondata Standalone Built and tuned at ImportBuilders- an engine is only as good as the person building and tuning it Expect 200+ whp