.:HSTuners::

thermal · 11-07-2006, 08:54 PM

Did you bleed the slave already?

Remember, what makes the pedal go back up is the pressure plate pushing the piston inside the slave cylinder. In other words, your clutch.... at least your clutch pressure plate.... might be going bad.

Also, if you are felling a little bit of vibration and noise during shifting, it might be your throw out bearing going bad.

Either way, if bleeding does not fix it, you will have to pull the tranny out....

11-07-2006, 08:54 PM	#2
thermal Banning Machine Join Date: Aug 2001 Location: My Garage, Va. Posts: 5,547	Did you bleed the slave already? Remember, what makes the pedal go back up is the pressure plate pushing the piston inside the slave cylinder. In other words, your clutch.... at least your clutch pressure plate.... might be going bad. Also, if you are felling a little bit of vibration and noise during shifting, it might be your throw out bearing going bad. Either way, if bleeding does not fix it, you will have to pull the tranny out.... __________________ Project Teg Visit the Turbo Forum Last edited by thermal : 11-07-2006 at 08:58 PM.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode