.:HSTuners::

thermal · 03-15-2006, 12:30 PM

If you use a DSM manifold, you will have redrill a couple of holes to match the exhaust port. Another issue is that you will have to get an adapter flange going from the manifold to a T3 flange (for a T3T04). The manifold will either have a T25 flange or 14b flange. As far as the T3T04 fitment, I'm not sure how much room you have alloted for while using a DSM manifold. Go search on HMT. They will have a better answer for you. Contact BMC on HMT for the adapter flange. Goodluck

03-15-2006, 12:30 PM	#1
thermal Banning Machine Join Date: Aug 2001 Location: My Garage, Va. Posts: 5,547	If you use a DSM manifold, you will have redrill a couple of holes to match the exhaust port. Another issue is that you will have to get an adapter flange going from the manifold to a T3 flange (for a T3T04). The manifold will either have a T25 flange or 14b flange. As far as the T3T04 fitment, I'm not sure how much room you have alloted for while using a DSM manifold. Go search on HMT. They will have a better answer for you. Contact BMC on HMT for the adapter flange. Goodluck __________________ Project Teg Visit the Turbo Forum

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode