.:HSTuners::

*pdiggitydogg* · 01-20-2006, 12:24 PM

Perhaps the knock sensor is faulty - have you checked it with a multimeter? Using shielded wire? Wire continuity w/ ecu? Cleaned the threads (sensor is self-grounded to the block)? Torqued correctly?

A lot of VSS issues are actually from a bad connection - clean the connector w/ brake/carb cleaner, throw on some dielectric grease, and go from there.
If it still gives you trouble, I suggest testing a different vss, and then wiring after that.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode

01-20-2006, 12:24 PM	#1
pdiggitydogg Yahoo Watashi wa kattaze! Join Date: May 2002 Location: Meanwhile, up in The D... Age: 42 Posts: 10,579	Perhaps the knock sensor is faulty - have you checked it with a multimeter? Using shielded wire? Wire continuity w/ ecu? Cleaned the threads (sensor is self-grounded to the block)? Torqued correctly? A lot of VSS issues are actually from a bad connection - clean the connector w/ brake/carb cleaner, throw on some dielectric grease, and go from there. If it still gives you trouble, I suggest testing a different vss, and then wiring after that.