.:HSTuners::

thermal · 01-06-2006, 06:01 AM

Just make sure you mark some of the plugs. The IAT and IACV looks very similar. It is a 2-prong clip. I almost made that mistake before. Dont worry too much about the location of the sensors. Skunk2 products are highly R&D'd. Some of your vacuum lines may have to be modified as far as length, but nothing too complicated................ If you have any problems, post a pic and I'm sure one of us can figure it out.

01-06-2006, 06:01 AM	#2
thermal Banning Machine Join Date: Aug 2001 Location: My Garage, Va. Posts: 5,547	Just make sure you mark some of the plugs. The IAT and IACV looks very similar. It is a 2-prong clip. I almost made that mistake before. Dont worry too much about the location of the sensors. Skunk2 products are highly R&D'd. Some of your vacuum lines may have to be modified as far as length, but nothing too complicated................ If you have any problems, post a pic and I'm sure one of us can figure it out. __________________ Project Teg Visit the Turbo Forum

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode