.:HSTuners::

01-28-2002, 10:58 AM

Not yet. I am in the process of building it.

When I do run it I am going to see if it is necessary to run past 10K. Ideally 9,000 rpm should be plenty. Shifts at 10,000 rpm is pretty hard on the tranny let alone the motor.

The cams I am using should allow for torque production in the 9,000 rpm range which will make for a screamer but will provide good power 6500 rpm and up.

Having as rigid components as possible helps keep everything tidy at the extreme rpm. That's my reasoning behind the GSR crank.

01-28-2002, 10:58 AM	#16
Rocket Posts: n/a	10k RPM Not yet. I am in the process of building it. When I do run it I am going to see if it is necessary to run past 10K. Ideally 9,000 rpm should be plenty. Shifts at 10,000 rpm is pretty hard on the tranny let alone the motor. The cams I am using should allow for torque production in the 9,000 rpm range which will make for a screamer but will provide good power 6500 rpm and up. Having as rigid components as possible helps keep everything tidy at the extreme rpm. That's my reasoning behind the GSR crank.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode