.:HSTuners::

Jazn671 · 03-04-2005, 10:40 PM

i would buy the acura rebuild kit. i like oem parts over autozone...
valve jobs is cutting the valve seat. 3 angle = cut at 3 different angles, 5 angle = cut at 5 different angles. 5 is custom and normally you'll have to provide specs or degrees at which you wish cut. 3 angle's pretty standard and most machine shops use that standard. since this sounds like a budget boost build, i'd run a block guard and low compression head gasket.

03-04-2005, 10:40 PM	#1
Jazn671 1st Gear Join Date: Dec 2002 Location: Illinois Age: 45 Posts: 74	i would buy the acura rebuild kit. i like oem parts over autozone... valve jobs is cutting the valve seat. 3 angle = cut at 3 different angles, 5 angle = cut at 5 different angles. 5 is custom and normally you'll have to provide specs or degrees at which you wish cut. 3 angle's pretty standard and most machine shops use that standard. since this sounds like a budget boost build, i'd run a block guard and low compression head gasket. __________________ Suja 1 Motoring 502 E St. Charles Carol Stream, IL 60188 630-407-0711 www.suja1.com AIM:Jazn671

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode