.:HSTuners::

01-22-2002, 12:12 PM

probably go with je pistons and crower rods. there is really no need to get a thicker head gasket unless you are trying to drop the compression.. hks makes one and greddy is soon coming out with one. otherwise you might look into sending the block to bensons, or the whole motor for that matter.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode

01-22-2002, 12:12 PM	#1
BlazinCrx Posts: n/a	probably go with je pistons and crower rods. there is really no need to get a thicker head gasket unless you are trying to drop the compression.. hks makes one and greddy is soon coming out with one. otherwise you might look into sending the block to bensons, or the whole motor for that matter.