.:HSTuners::

thermal · 09-10-2004, 12:18 PM

Install your boost gauge and whatever else gauges you plan to use. You can still use the boost gauge without the turbo. It just wont pass the "0" reading. Wire your turbo timer as well. If you already have the intercooler, go ahead mount it or at least star making measurements.

As far the AFC set-point on stock motor N/A, just play around between +2 to +4 points of fuel on all RPM's and see what happens. Make sure you set the sensor on 6 in and 6 out. Set the car type to 4 arrow up. Leave the TH-point as is until you start boosting. Later

09-10-2004, 12:18 PM	#1
thermal Banning Machine Join Date: Aug 2001 Location: My Garage, Va. Posts: 5,547	Install your boost gauge and whatever else gauges you plan to use. You can still use the boost gauge without the turbo. It just wont pass the "0" reading. Wire your turbo timer as well. If you already have the intercooler, go ahead mount it or at least star making measurements. As far the AFC set-point on stock motor N/A, just play around between +2 to +4 points of fuel on all RPM's and see what happens. Make sure you set the sensor on 6 in and 6 out. Set the car type to 4 arrow up. Leave the TH-point as is until you start boosting. Later __________________ Project Teg Visit the Turbo Forum

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode