.:HSTuners::

08-24-2004, 07:38 PM

a shop normally will use a fine grit cleaner and high speed buffer to remove them and sometimes cost a arm and leg..lol

Unless you have a hookup like some.
If you try it w/ thinners I would recommend diluting it a ltitle and as mentioned use a Q-Tip to apply the solution. Once you are finished I would wash and then wax that area. Hope this may help and good luck w/ what you do or did..

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode

08-24-2004, 07:38 PM	#1
4drmadness Posts: n/a	a shop normally will use a fine grit cleaner and high speed buffer to remove them and sometimes cost a arm and leg..lol Unless you have a hookup like some. If you try it w/ thinners I would recommend diluting it a ltitle and as mentioned use a Q-Tip to apply the solution. Once you are finished I would wash and then wax that area. Hope this may help and good luck w/ what you do or did..