.:HSTuners::

thermal · 03-06-2004, 07:01 PM

dude, where the fuk you at in Va? If you are even close by Va Beach, come visit me and I'll hook that biatch up in 30 minutes tops..... Is your ECU stock or modified?

Here:
http://www.apexi-usa.com/productdocu..._safc_wire.pdf

Find the diagram H-2a and bounce that off the main diagram. H2a will only tell you which pin. It will not tell you which one should be tapped or cut/connect. The only wire that should be cut and connected is the MAP signal.

All OBD1 wiring clips should be the same..... Goodluck

03-06-2004, 07:01 PM	#2
thermal Banning Machine Join Date: Aug 2001 Location: My Garage, Va. Posts: 5,547	dude, where the fuk you at in Va? If you are even close by Va Beach, come visit me and I'll hook that biatch up in 30 minutes tops..... Is your ECU stock or modified? Here: http://www.apexi-usa.com/productdocu..._safc_wire.pdf Find the diagram H-2a and bounce that off the main diagram. H2a will only tell you which pin. It will not tell you which one should be tapped or cut/connect. The only wire that should be cut and connected is the MAP signal. All OBD1 wiring clips should be the same..... Goodluck __________________ Project Teg Visit the Turbo Forum

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode