.:HSTuners::

thermal · 03-04-2004, 09:26 PM

slowly pull the wire off. Use a deep socket. I used an adjustable wrench on mine, I think. That sensor shouldnt be too tight since you probably have not pulled it out before... it should be still torqued properly. If it starts pissin you off, get a GReddy oil filter "sandwich". Nice shit man. It has 3 holes that will allow you to later tap in for an oil pressure gauge. I'm using all 3 of them for my set-up: turbo oil feed, oil pressure, and oil temp.

03-04-2004, 09:26 PM	#1
thermal Banning Machine Join Date: Aug 2001 Location: My Garage, Va. Posts: 5,547	slowly pull the wire off. Use a deep socket. I used an adjustable wrench on mine, I think. That sensor shouldnt be too tight since you probably have not pulled it out before... it should be still torqued properly. If it starts pissin you off, get a GReddy oil filter "sandwich". Nice shit man. It has 3 holes that will allow you to later tap in for an oil pressure gauge. I'm using all 3 of them for my set-up: turbo oil feed, oil pressure, and oil temp. __________________ Project Teg Visit the Turbo Forum

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode