.:HSTuners::

blind34_1 · 02-13-2004, 11:11 PM

to not be too in depth...

remove any black plastic tubing from your throttle body to whereever it ends.

fit the tubing up to the throttle body.

tighten it down.

It's pretty hard to screw it up. There are like two tubes you may have to relocate, one is a breather tube from the valve cover, and the other...i cant remember. But obviously it has to do with equalizing pressure. Don't worry about them too much.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

02-13-2004, 11:11 PM	#3
blind34_1 Registered User Join Date: May 2002 Location: IL Age: 41 Posts: 1,813	to not be too in depth... remove any black plastic tubing from your throttle body to whereever it ends. fit the tubing up to the throttle body. tighten it down. It's pretty hard to screw it up. There are like two tubes you may have to relocate, one is a breather tube from the valve cover, and the other...i cant remember. But obviously it has to do with equalizing pressure. Don't worry about them too much.