.:HSTuners::

12-30-2003, 05:15 PM

should work fine, the piping may be a lil different, but thats what fabricating is for, the chassis are a lil different. As the previous guy noted, wire the FMU (blue Box) in accordance w/ an OBD1 version. It is preset (wastegate) for 7.9psi. Also I might note the injectors included in the kit are OBD2 so you'll have to notch your plugs or change over your pig-tails to OBD2. Can't remember if they can be notched or not. And I highly recommend an Apexi AFC for broadning the fuel curve if you expect to run more boost. Upgrade that fuel pump also. Good luck.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode

12-30-2003, 05:15 PM	#1
Importrepairguy Posts: n/a	should work fine, the piping may be a lil different, but thats what fabricating is for, the chassis are a lil different. As the previous guy noted, wire the FMU (blue Box) in accordance w/ an OBD1 version. It is preset (wastegate) for 7.9psi. Also I might note the injectors included in the kit are OBD2 so you'll have to notch your plugs or change over your pig-tails to OBD2. Can't remember if they can be notched or not. And I highly recommend an Apexi AFC for broadning the fuel curve if you expect to run more boost. Upgrade that fuel pump also. Good luck.