.:HSTuners::

Duckydos · 07-15-2003, 09:15 PM

It depends on the gauges you got. If it is several different "wafers" (one for speedo, one for tach, etc.) then no, you do not have to take off the needles. Rather, just carefully slip the needle through hole and you should be good to go.
Now, if the gauges are just one giant sheet, you will have to take off the needles (if that's even possible on Honda's), lay the sheet over, and reattach the needles. I don't see where you'll have to do this.

Need anymore help, just ask.

-Ducky

07-15-2003, 09:15 PM	#2
Duckydos Registered User Join Date: Mar 2003 Location: Orlando, FL Age: 41 Posts: 1,048	It depends on the gauges you got. If it is several different "wafers" (one for speedo, one for tach, etc.) then no, you do not have to take off the needles. Rather, just carefully slip the needle through hole and you should be good to go. Now, if the gauges are just one giant sheet, you will have to take off the needles (if that's even possible on Honda's), lay the sheet over, and reattach the needles. I don't see where you'll have to do this. Need anymore help, just ask. -Ducky __________________ Had an Accord. Then I had something European. Now I have an SCCA Solo-II monster!

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode