.:HSTuners::

slowEJ6 · 05-22-2003, 02:35 AM

anyway, on your EX motor. you can use toyota 1G-GTE pistons (dont forget the 1G piston rings too) w/ b16a rods & rod bearings and thats good for about 1.2bar if not a little more with PROPER/GOOD tuning......the block has to be notched for the rods but thats no biggie......

dont forget ecu/fuel management either......but this should easily get you in the 12's.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

05-22-2003, 02:35 AM	#11
slowEJ6 Registered User Join Date: Nov 2001 Location: Oviedo, FL Age: 43 Posts: 3,195	anyway, on your EX motor. you can use toyota 1G-GTE pistons (dont forget the 1G piston rings too) w/ b16a rods & rod bearings and thats good for about 1.2bar if not a little more with PROPER/GOOD tuning......the block has to be notched for the rods but thats no biggie...... dont forget ecu/fuel management either......but this should easily get you in the 12's.