.:HSTuners::

05-04-2003, 09:14 PM

1. the housing is different ( you want an E housing )

2. Handatas not bad if you can get a good workgin unit from them. I was a dealer for 2 weeks till 3 of my first 3 units were bad. I like my AEM EMS

3. They are all going to work at 10 psi you have listed as maximum. Id go with a 35mm Tial if you must have a brand name

4. Steel (tubular) you can make more creative designs to increase power but with cast you stay cost effecient. A good tubular manifold can run you 600+

5. If you do EMS you can use that or jsut go with a Profec B. That is an electric controller not a mbc as mentioned above

6. PWR all the way, cheap and the best on the market

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode

05-04-2003, 09:14 PM	#1
Boosted3g Posts: n/a	1. the housing is different ( you want an E housing ) 2. Handatas not bad if you can get a good workgin unit from them. I was a dealer for 2 weeks till 3 of my first 3 units were bad. I like my AEM EMS 3. They are all going to work at 10 psi you have listed as maximum. Id go with a 35mm Tial if you must have a brand name 4. Steel (tubular) you can make more creative designs to increase power but with cast you stay cost effecient. A good tubular manifold can run you 600+ 5. If you do EMS you can use that or jsut go with a Profec B. That is an electric controller not a mbc as mentioned above 6. PWR all the way, cheap and the best on the market