.:HSTuners::

*pdiggitydogg* · 03-26-2003, 08:10 PM

No this is the right place for this kind of Q

If you fix it right, you shouldnt have anymore problems...but it depends on the level of the fix...if you have any kind of crack...its fried...time for a new block/head/engine

The USDM b16a2 does tend to cost a bit more than the JDM because its a lot more rare. Plus, if you ask me I recommend a b18c1 because it has more torque and since youre already spending the money for a new engine...why not spend a few hundred more and get one w/ more power and more potential? The ZC is a good engine too, very affordable, but even the dohc only around the power of a d16y8...plus theyre generally put into CRX platform.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

03-26-2003, 08:10 PM	#3
pdiggitydogg Yahoo Watashi wa kattaze! Join Date: May 2002 Location: Meanwhile, up in The D... Age: 42 Posts: 10,579	No this is the right place for this kind of Q If you fix it right, you shouldnt have anymore problems...but it depends on the level of the fix...if you have any kind of crack...its fried...time for a new block/head/engine The USDM b16a2 does tend to cost a bit more than the JDM because its a lot more rare. Plus, if you ask me I recommend a b18c1 because it has more torque and since youre already spending the money for a new engine...why not spend a few hundred more and get one w/ more power and more potential? The ZC is a good engine too, very affordable, but even the dohc only around the power of a d16y8...plus theyre generally put into CRX platform.