.:HSTuners::

03-23-2003, 10:41 PM

I used a hi-temp. rubber foam "make a gasket" and there is no leak...but as far as the o ring, it is in excelent condition so i didn't replace it...but i do see the problem about the distrubutor needing to move for timing. But I don't plan on messing with that for performance reasons, and so i suspect that it may never need attention. Well I hope any way.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode

03-23-2003, 10:41 PM	#1
davi Posts: n/a	I used a hi-temp. rubber foam "make a gasket" and there is no leak...but as far as the o ring, it is in excelent condition so i didn't replace it...but i do see the problem about the distrubutor needing to move for timing. But I don't plan on messing with that for performance reasons, and so i suspect that it may never need attention. Well I hope any way.