|
Yeah, I've tried kicking. It only resulted it sore toes. I even replaced that rear crossmember up front because the old one was bent right where the arm bolted in.
What do you guys think about relocating the studs that come into the engine bay from the strut tower? I was thinking about torching the original holes to allow me to move the top of the tower inward, towards the center of the car, bringing the top of the tire in with it. Then I would weld some washers or something to the new location to mount those studs too. Does this sound like it could work? I'm affraid that the welds won't hold and that I'll end up not even being able to mount it in the original location. This is all that I know to do though.... other than pay $1,000 that I don't have to have all the suspension parts replaced... again.
Jesse
|
12-30-2002, 07:39 AM
Threaded Mode