.:HSTuners::

12-09-2002, 05:35 PM

the easiest way is to do what i did. Get the motor sleeved by golden eagle with a deck plate. Their largest deck plate on an LS motor is .633 inches. At .633 inches you can use an off the shelf Eagle rod. All this will cost you an extra 395 bucsk but you can end up with a 2.0 LS/vtec with a 1.72 r/s ratio that can use off the shelf pistons. You can also use the stock timing belt with a block off plate for the water pump which is included in the price.

Josh

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode

12-09-2002, 05:35 PM	#1
Boosted3g Posts: n/a	the easiest way is to do what i did. Get the motor sleeved by golden eagle with a deck plate. Their largest deck plate on an LS motor is .633 inches. At .633 inches you can use an off the shelf Eagle rod. All this will cost you an extra 395 bucsk but you can end up with a 2.0 LS/vtec with a 1.72 r/s ratio that can use off the shelf pistons. You can also use the stock timing belt with a block off plate for the water pump which is included in the price. Josh