i recently replaced my bumper lights on my 91 accord too. The installation was easier than i thought it would be. From what i can remember, i pulled on the rubber to make it loose around the bumper light. Then there was a clip in which i needed to SLIDE the light out, and finally pulling the other side out slowly. The only attachments made to the bumper lights are the wiring and a plug in the back. Once those are removed, just do the opposite to place them back in. However, when i was placing my last clear light in, the clip wouldnt go back into place. I ended up super glueing all sides of the light onto the car. Might seem cheap, but it's been holding on for almost a month now. If you need more help, simply reply and i'll check my car again.
