PDA

View Full Version : Question on Type R Swap. Shaking?


ablangc
12-03-2002, 03:03 PM
No, this in not the typical question you think that I may ask. Currently I have a 99 Civic EX Coupe with a 2000 JDM ITR Engine. The problem is when I accelerate only. When I step on the gas pedal and at around 3000-5000 rpms, I can feel and see the car shake (not violently or vibrating). I have come to a couple of conclusions. Fuel filter needs to be replaced, fuel leak somewhere (I can smell a hint a fuel when I open the engine bay but I think that may be normal), or it could be the drivers side pillow mount is bad and needs to be replaced. I have read that the drivers side pillow mount tends to be defective on EK civics. I find it strange though that I just replaced it with a brand new pillow mount (OEM) when I bought the engine 3 months ago and doubt that it will go bad that fast even though they are defective to begin with. But if need be I will replace it with a Place Racing pillow mount. Oh well, any suggestions comments concerns?? Any help would be greatly appreciated. Thanks.

Addict
12-03-2002, 03:13 PM
Well without feeling its tough. But you shouldn't smell fuel at all.

Double check you lines, fuel rail, etc. Is it more of a stuttering?

ebpda9
12-03-2002, 03:25 PM
i had the same problem with my accord. i fixed it off with a polyurethane front mount, and never had problems since

ebpda9
12-03-2002, 03:26 PM
also there is a problem with the inner cv joints on some cars that cause the car to shake have those inspected too

ablangc
12-04-2002, 03:43 AM
oh shit! I think you hit the mark, my inner cv boot is cracked and leaking all over the place. Why didn't I see that. You think that might be the problem? I really hope so. Thanks! Anybody have anymore suggestions?

iRACEmyCTR
12-04-2002, 03:31 PM
ya def the cv joints or mounts, you fuel lines should have been checked upon the swap and it's harder to make sure you do the axels and mounts correctly