.:HSTuners::

05-29-2003, 09:40 AM

My car's got a problem.
When you turn the key, it makes a grinding sound. Like the starter's not really getting a good hold of the flywheel and making the engine turn. If I roll the car a little with it in gear (clutch in) then sometimes it starts. I can't really get a good look into the place I need to, but I think that I lost a lot of teeth on the flywheel and was looking for a little confirmation. Oh, and does anyone know the going rate for labor on this job. The last time I had it done (when I got the JUN installed) it was something like 500 for labor, that still about right?

05-29-2003, 07:41 PM

it sounds like your missing teeth on the flywheel to me

Jazn671 · 06-14-2003, 07:33 PM

$500's about right... did u visually check if you're missing a teeth?

06-16-2003, 05:46 AM

Yeah, I pulled the starter off and checked to see if there was teeth missing. It's got some gone in a little section, and some more radomly through the wheel. I'm suprised by it though, because it's JUN, and steel. I didn't think that steel would crack like that, seeing that I work on metal for a living and know a little about metalurgy myself.

05-29-2003, 09:40 AM	#1
dudeman47 Posts: n/a	Flywheel My car's got a problem. When you turn the key, it makes a grinding sound. Like the starter's not really getting a good hold of the flywheel and making the engine turn. If I roll the car a little with it in gear (clutch in) then sometimes it starts. I can't really get a good look into the place I need to, but I think that I lost a lot of teeth on the flywheel and was looking for a little confirmation. Oh, and does anyone know the going rate for labor on this job. The last time I had it done (when I got the JUN installed) it was something like 500 for labor, that still about right?

06-14-2003, 07:33 PM	#3
Jazn671 1st Gear Join Date: Dec 2002 Location: Illinois Age: 44 Posts: 74	$500's about right... did u visually check if you're missing a teeth? __________________ Suja 1 Motoring 502 E St. Charles Carol Stream, IL 60188 630-407-0711 www.suja1.com AIM:Jazn671

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

05-29-2003, 07:41 PM	#2
Shot 2 Hel Posts: n/a	it sounds like your missing teeth on the flywheel to me

06-16-2003, 05:46 AM	#4
dudeman47 Posts: n/a	Yeah, I pulled the starter off and checked to see if there was teeth missing. It's got some gone in a little section, and some more radomly through the wheel. I'm suprised by it though, because it's JUN, and steel. I didn't think that steel would crack like that, seeing that I work on metal for a living and know a little about metalurgy myself.