.:HSTuners::


::Hondas Wanted::
 

Go Back   HSTuners > Honda / Acura Cars > Integra
User Name
Password
FAQ Members List Calendar Mark Forums Read

Reply
 
Thread Tools Display Modes
Old 11-07-2006, 11:00 AM   #1
IALuder
Registered User
 
IALuder's Avatar
 
Join Date: Sep 2003
Location: Des Moines IA
Age: 37
Posts: 7,908
need help helpin a friend

ok, so since the jeep is still in the shop ive been daily driving the integra for a few weeks now. all is well except every once in a while Ill go to slow down to a stop light and i need to pull it into neutral but the clutch pedal is sitting on the floor with no pressure and I have to pump it to get pressure back into it. Not a huge deal but I just replaced the clutch master cylander late this summer and cleaned all the lines out. Its got 450 degree fluid in it instead of stock. Still stock slave cylander. could the slave cylander be bad or should I not have put so much trust in oreillys clutch master cylanders? Could the fluid be acting up in the cold weather? Im not losing any fluid, its still right where I left it this summer and its still clear and clean. This only happenes about once every 100 miles of driving. Let me know what you guys think
__________________
93 Si H23vtec......soon to be 12lbs
95 Civic EX....automatic DD

if you cant dazzle them with your brillance, baffle them with your bullshit.
IALuder is offline   Reply With Quote
Old 11-07-2006, 08:54 PM   #2
thermal
Banning Machine
 
thermal's Avatar
 
Join Date: Aug 2001
Location: My Garage, Va.
Posts: 5,547
Did you bleed the slave already?

Remember, what makes the pedal go back up is the pressure plate pushing the piston inside the slave cylinder. In other words, your clutch.... at least your clutch pressure plate.... might be going bad.

Also, if you are felling a little bit of vibration and noise during shifting, it might be your throw out bearing going bad.

Either way, if bleeding does not fix it, you will have to pull the tranny out....
__________________


Project Teg

Visit the Turbo Forum

Last edited by thermal : 11-07-2006 at 08:58 PM.
thermal is offline   Reply With Quote
Old 11-07-2006, 09:20 PM   #3
IALuder
Registered User
 
IALuder's Avatar
 
Join Date: Sep 2003
Location: Des Moines IA
Age: 37
Posts: 7,908
yea, we bleed it.
__________________
93 Si H23vtec......soon to be 12lbs
95 Civic EX....automatic DD

if you cant dazzle them with your brillance, baffle them with your bullshit.
IALuder is offline   Reply With Quote
Old 01-13-2010, 05:06 PM   #4
ShagginJet
Registered User
 
ShagginJet's Avatar
 
Join Date: Jan 2002
Location: Los Angeles
Posts: 1,584
I had this issue on my 91 'Teg for about two months, eventually the car got stuck in first gear and I had to leave it on the side of the road, then returned at 2am and drove it home in 1st/2nd. (did u know you can shift WITHOUT the clutch if your speed is just right??)

After dismantling the clutch from the engine, I found that one of the small springs in the clutch plate had snapped in half and was free floating (messing sht up a lot.) Picked up a clutch kit from a local retailer, NPK I think. Had the flywheel resurfaced. Replaced all parts and re-assembled, adjusted cable to take all slack... ran mellow for first 1k miles, works like a charm, grabs hard after about 5k miles added; I couldn't be happier.

Hope that helps, I bet your clutch is slowly going out.
__________________
RECENTLY UPDATED!!! 5-20-04

http://63.249.135.19/hdrive/car/index.htm
ShagginJet is offline   Reply With Quote
Old 01-23-2010, 10:32 PM   #5
slowEJ6
Registered User
 
slowEJ6's Avatar
 
Join Date: Nov 2001
Location: Oviedo, FL
Age: 42
Posts: 3,195
3 yrs later, awesome reply!
slowEJ6 is offline   Reply With Quote
Reply


Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

vB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump


All times are GMT -5. The time now is 06:53 AM.


Powered by vBulletin Version 3.5.3
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
© 2006 HSTuners.com