.:HSTuners::::Hondas Wanted:: |
06-24-2003, 06:42 PM
|
#1 |
|
2nd Gear
Join Date: Nov 2002
Location: AZ@
Age: 42
Posts: 207
|
Mandrel Bent... What Does That Mean?
no clue what that means... what's the difference between something else? Do they use pressure to mandrel bend things? or heat? or how, who, what, where, when, why?
__________________
The name is Tom, I am da bomb, if you can't remember, just ask yo' mom. |
|
|
|
06-24-2003, 06:57 PM
|
#2 |
|
5th Gear
Join Date: Sep 2002
Location: Orange County, Southern California
Age: 38
Posts: 1,490
|
mandrel bending is the process of bending a pipe.... through a particulat machine that allows for the tube to be bent without any "crushes" in it.
__________________
 everyone loves the turbizzim. |
|
|
|
|
06-24-2003, 07:04 PM
|
#3 |
|
2nd Gear
Join Date: Nov 2002
Location: AZ@
Age: 42
Posts: 207
|
can they use pressure to bend metal pipes.. is that considered mandrel bent?
__________________
The name is Tom, I am da bomb, if you can't remember, just ask yo' mom. |
|
|
|
|
06-24-2003, 07:15 PM
|
#4 |
|
5th Gear
Join Date: Sep 2002
Location: Orange County, Southern California
Age: 38
Posts: 1,490
|
pressure?
__________________
everyone loves the turbizzim. |
|
|
|
|
06-24-2003, 10:09 PM
|
#5 |
|
Registered User
Join Date: Mar 2003
Location: Atlanta
Age: 36
Posts: 1,325
|
The mandrel actually goes inside the tubing and is held by a mandrel rod to support the tubing at the opposite point of the bend. The mandrel is then taken out after the bend is complete or within the last few degrees of bending. This way in the tubing being the same diameter through the straight tubing as in the bend radius. So if you started with 2" pipe and bent it into a 90 degree bend it is still 2" through the entire bend radius. basily what is does it suports the metal to it doesnt "cave in" or loose a round shape during the bend... and pressure bending is when you put a piece of metal in a shoe and u have a rammer.. and yea it rams it into shape... that whare u get the term"pressure" bending from... any other questions????
Last edited by pimpinprelude : 06-24-2003 at 10:30 PM. |
|
|
|
|
06-26-2003, 10:52 PM
|
#6 |
|
1st Gear
Join Date: Jan 2003
Location: North Carolina
Age: 42
Posts: 62
|
good job pimpinprelude. so basically it keeps the same diameter throughout wiithout losing diameter in the bends
|
|
|
|
|
06-30-2003, 09:02 PM
|
#7 |
|
Registered User
Join Date: Mar 2003
Location: Atlanta
Age: 36
Posts: 1,325
|
yup thats it....
 |
|
|
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
