.:HSTuners::

wal · 05-05-2004, 03:29 AM

hi ppl i managed to get hold of a honda civic coupe, 95 reg. it has a d15b7 in i think, its non vtec. However i need more get up and go. i was thinkin about a b16a2 or 3 transplant but since i have no vtec installed, would it be easier to put in a b18 engine? since some off them dont have vtec?

*pdiggitydogg* · 05-05-2004, 09:50 AM

b18's...some meaning 1 of them?

It would be easier, because you wouldnt have to run like 4 extra wires, yes. But doing that isnt hard. You just run them from the component to the ecu

wal · 05-07-2004, 04:02 AM

but will i have the connections for vtec because ma engine is not vtec anyways so will it have the conection points for vtec?? and what would be easier swap between b16a2/3 or b18 gsr?

*pdiggitydogg* · 05-07-2004, 09:58 AM

you have to run the wires from the physical items (ie- solenoid) to the ecu. Like wiring an amp...only kinda different.
The b16 would be easier just because you dont need to wire the 2ndary butterfly crap or run another wire set for the baro sensor...plus knock and vtec

05-05-2004, 03:29 AM	#1
wal 2nd Gear Join Date: Feb 2004 Location: north east, uk Age: 40 Posts: 116	ye olde civic hi ppl i managed to get hold of a honda civic coupe, 95 reg. it has a d15b7 in i think, its non vtec. However i need more get up and go. i was thinkin about a b16a2 or 3 transplant but since i have no vtec installed, would it be easier to put in a b18 engine? since some off them dont have vtec?

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

05-05-2004, 09:50 AM	#2
pdiggitydogg Yahoo Watashi wa kattaze! Join Date: May 2002 Location: Meanwhile, up in The D... Age: 40 Posts: 10,579	b18's...some meaning 1 of them? It would be easier, because you wouldnt have to run like 4 extra wires, yes. But doing that isnt hard. You just run them from the component to the ecu

05-07-2004, 04:02 AM	#3
wal 2nd Gear Join Date: Feb 2004 Location: north east, uk Age: 40 Posts: 116	but will i have the connections for vtec because ma engine is not vtec anyways so will it have the conection points for vtec?? and what would be easier swap between b16a2/3 or b18 gsr?

05-07-2004, 09:58 AM	#4
pdiggitydogg Yahoo Watashi wa kattaze! Join Date: May 2002 Location: Meanwhile, up in The D... Age: 40 Posts: 10,579	you have to run the wires from the physical items (ie- solenoid) to the ecu. Like wiring an amp...only kinda different. The b16 would be easier just because you dont need to wire the 2ndary butterfly crap or run another wire set for the baro sensor...plus knock and vtec