.:HSTuners::

02-10-2004, 02:22 AM

Can anyone give me advice on how to remove a stripped screw??? Its the center screw on the bumper of an 88 CRX SI.

02-10-2004, 09:36 AM

break it and retap it.....

blind34_1 · 02-10-2004, 01:04 PM

craftsman makes a drill bit set that is designed to remove rounded off bolts. Get a good drill (not portable) and go to town on it. It basically grinds it self into the bolt, grabs it, and then you are allowed to pull it out.

actually now that I think about it, that would help you much if the threads are stripped...duh. You might just want to drill it.

I don't now how accessible this bolt is, but a lot of times I have luck getting a very small flathead underneath the head of the bolt, and apply upward pressure on it. That can sometimes allow the remaining thread to maybe catch, and then you can screw it out the rest of the way. follow me?

02-11-2004, 09:04 AM

Thanks for the advice everybodt

02-11-2004, 07:34 PM

if it;s the bumper screw you can normally get a good set of channel locks on the head as it's raised and just undo them like that. I have used that methond for a many front/rear bumper screws.... hope this may also help...

02-12-2004, 05:02 AM

thanks

02-10-2004, 02:22 AM	#1
MegaDON Posts: n/a	Stripped Screw !!! Can anyone give me advice on how to remove a stripped screw??? Its the center screw on the bumper of an 88 CRX SI.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

02-10-2004, 09:36 AM	#2
vtracer20 Posts: n/a	break it and retap it.....

02-10-2004, 01:04 PM	#3
blind34_1 Registered User Join Date: May 2002 Location: IL Age: 39 Posts: 1,813	craftsman makes a drill bit set that is designed to remove rounded off bolts. Get a good drill (not portable) and go to town on it. It basically grinds it self into the bolt, grabs it, and then you are allowed to pull it out. actually now that I think about it, that would help you much if the threads are stripped...duh. You might just want to drill it. I don't now how accessible this bolt is, but a lot of times I have luck getting a very small flathead underneath the head of the bolt, and apply upward pressure on it. That can sometimes allow the remaining thread to maybe catch, and then you can screw it out the rest of the way. follow me?

02-11-2004, 09:04 AM	#4
MegaDON Posts: n/a	Thanks for the advice everybodt

02-11-2004, 07:34 PM	#5
4drmadness Posts: n/a	if it;s the bumper screw you can normally get a good set of channel locks on the head as it's raised and just undo them like that. I have used that methond for a many front/rear bumper screws.... hope this may also help...