.:HSTuners::::Hondas Wanted:: |
08-26-2005, 12:41 PM
|
#1 |
|
Yahoo Watashi wa kattaze!
Join Date: May 2002
Location: Meanwhile, up in The D...
Age: 40
Posts: 10,579
|
Need cables...wtf
I bought a drive, was told it came w/ cables...it did not. I bitched, I yelled, they wont cooperate (I f*cking hate ebay anymore...)
SO...what cables do I need? IDE, I know...power, sure. If I roll into compusa, they'll have this, right? This is all I got...a drive. I'll probably need a sheath and screws? |
|
|
|
08-26-2005, 02:32 PM
|
#2 |
|
Repost Wagon
Join Date: Dec 2001
Location: over here
Age: 43
Posts: 17,266
|
all you need is the ide cable that's it. get a 40 pin 80 wire ribbon. they work a lot better on the ata 100/133 drives.
__________________
 
|
|
|
|
|
08-26-2005, 03:18 PM
|
#3 |
|
Yahoo Watashi wa kattaze!
Join Date: May 2002
Location: Meanwhile, up in The D...
Age: 40
Posts: 10,579
|
will the mother board have the rest then?
|
|
|
|
|
08-26-2005, 11:24 PM
|
#4 |
|
Repost Wagon
Join Date: Dec 2001
Location: over here
Age: 43
Posts: 17,266
|
are you replacing any of the cd drives ?
here are the cables config from left to right as shown in your pic: digital audio output, analog audio output (can use the old one from your motherboard), the jumper pins, the ide cable, and the power cable (the power source should have it)
__________________
|
|
|
|
|
08-27-2005, 10:27 PM
|
#5 |
|
Yahoo Watashi wa kattaze!
Join Date: May 2002
Location: Meanwhile, up in The D...
Age: 40
Posts: 10,579
|
Im starting totally from scratch
Ive only bought the vid card, memory, this drive, and a stupid os |
|
|
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
