.:HSTuners::


::Hondas Wanted::
 

Go Back   HSTuners > Tech Talk > Step By Step
User Name
Password
FAQ Members List Calendar Mark Forums Read

Closed Thread
 
Thread Tools Display Modes
Old 09-12-2001, 08:06 PM   #1
Addict
Zoom-Zoom
 
Addict's Avatar
 
Join Date: Sep 2001
Location: Ohio
Posts: 3,924
Post Ingalls Rear Camber Kit Installation 92-00 Civic

Ingalls Rear Camber Kit Installation for 92-00 Civics
By Civic_Addict

Some of you may be asking “Why would you write a How-To on such an easy install?”. Well the answer is simple. Not everyone knows how to install a camber or even really what’s involved. I know I have seen several posts on various boards about the difficulty of this installation and it seems most don’t even know what the kit consists of. They just know they need it.
I take no responsibility for any damages that may occur. The instructions are provided as a guide. Also you may have to cut and paste the links below into a new browser window to view them


Tools Required:
14mm Socket
Ratchet & Extension (6” or more)
Hydraulic Jack or Lift
Jack from Trunk or an extra jack
Tire Iron from Trunk
PICTURE

Step One:
Jack car up using either hydraulic jack or lift and remove tire.

Step Two:
Ingalls says to remove one bolt at a time. Well if you do that you won’t be able to slide any spacers on the new bolts. Remove both bolts from the arm. This will be located near your spring (as you can see in the picture). You might want to loosen them both prior to actually removing them. Set the OEM bolts aside.
PICTURE

Step Three:
Each spacer will provide +1/4° of camber adjustment. So pull out your alignment sheet that you received when you had your car aligned (you did do this prior, right?). Look at the SPECIFIED RANGE area. This is where you need to be. Now look at the ACTUAL area. Now figure out what you need to add to that number to get into the SPECIFIED RANGE. It’s a negative number in the ACTUAL area so add until you are in the SPECIFIED RANGE. Ok now the hard part is done.
PICTURE
PICTURE

Step Four:
Now that you know how many spacers you need, you need to install the new bolts & spacers provided. The spacers go behind the bracket that’s attached to the arm. If you have trouble getting the suspension to move up when aligning the bolts, use the other jack. Place it under the lower control arm (connects behind the rear brake drum) and jack it up just enough to align the bolts. Do not jack it up too far. Install the new bolts and spacers. The proper torque spec on this is 26ft/lb.

After you complete both sides, you'll want to get an alignment once again. Its not neccessary, but is good to verify that you have the correct camber.
__________________
Quote:
Be who you are and say what you feel, because those who mind don't matter and those who matter don't mind.

Last edited by Addict : 01-29-2002 at 07:21 AM.
Addict is offline  
Closed Thread


Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

vB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump


All times are GMT -5. The time now is 08:32 PM.


Powered by vBulletin Version 3.5.3
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
© 2006 HSTuners.com