.:HSTuners::


::Hondas Wanted::
 

Go Back   HSTuners > Tech Talk > Step By Step
User Name
Password
FAQ Members List Calendar Mark Forums Read

Closed Thread
 
Thread Tools Display Modes
Old 09-06-2001, 01:00 AM   #1
VN-Tec
 
Posts: n/a
Removing a Oem Header for 4th/5th gen prelude

I. Remove original parts.

1. Remove the exhaust manifold cover. It is held in place by three bolts. The AC hosing in the front may be temporarly freed from its mount if there is not enough room to easily reach the third bolt.


2. Remove the original header and A pipe. The layout is 4-2-1 like the Mugen.

A. Loosen the A pipe. Start by appying a penetrant, such as Liquid Wrench, to the bolts. Then, unplug the oxygen sensor wire. Next, lube the hanger (I used Tri-Flow with Teflon).

One by one, loosen the bolts and nuts holding the A pipe to the catalytic converter, the mount and the exhaust manifold. There are eight in all.

B. Remove the A pipe and unscrew the oxygen sensor. Take special care with the oxygen sensor, if you plan on using it later.

C. Remove the heat insulator. Removing the small side heat insulator allows you to access the exhaust manifold self-locking nuts at the end.

D. Remove the exhaust manifold. After removing it, take off the left and right manifold stays, they will not be needed later. Finally, note the orientation of the manifold gasket and remove.

U are now headerless
 
Closed Thread


Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

vB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump


All times are GMT -5. The time now is 06:30 AM.


Powered by vBulletin Version 3.5.3
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
© 2006 HSTuners.com