.:HSTuners::

01-27-2002, 03:11 AM

Its a DX Motor and i'm dressing up the engine bay a bit. Is the valve cover just held on with the 4 bolts? Then it just comes up? I was reading that gaskets or seals have to be replaced if I take it off. Is it true? Do the bolts have to go back on with a very specific TORQUE or i'll run into probs? Any help appreciated. THanks.

01-27-2002, 03:11 AM	#1
insomniac Posts: n/a	Help Painting valve cover Its a DX Motor and i'm dressing up the engine bay a bit. Is the valve cover just held on with the 4 bolts? Then it just comes up? I was reading that gaskets or seals have to be replaced if I take it off. Is it true? Do the bolts have to go back on with a very specific TORQUE or i'll run into probs? Any help appreciated. THanks.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode