.:HSTuners::

12-21-2001, 11:13 AM

i have this wierd sound coming from the front end. i know my shafts are in need of repair, but this sound is harder than a bad cv joint. it only happens at low speed, during sharp corners. it is more of a clunk, grinding sound.

does anyone here no what it could be? what does a bad wheel bearing sound like?

its not as soft sounding as the cv joints.

any help is good help. THANX

Accord Man · 12-28-2001, 03:31 PM

Hello fellow Canadian!

When you get sounds at low speed, cornering.. bla bla

It's probably time to replace the bearings.. The balls are probably all crushed.

ebpda9 · 12-28-2001, 06:38 PM

change those damn bearings and it will go away. I had it on my accord and they dissapeared after a while, but i'm expecting them soon.

01-02-2002, 01:31 PM

thanx guys. i will do the shafts for sure and most likely the bearings too.

i have heard that you have to get the bearings pressed in. is this true?

ebpda9 · 01-04-2002, 10:01 AM

Yep it's true.

12-21-2001, 11:13 AM	#1
twoglude Posts: n/a	driveshaft noises/wheelbearings? i have this wierd sound coming from the front end. i know my shafts are in need of repair, but this sound is harder than a bad cv joint. it only happens at low speed, during sharp corners. it is more of a clunk, grinding sound. does anyone here no what it could be? what does a bad wheel bearing sound like? its not as soft sounding as the cv joints. any help is good help. THANX

12-28-2001, 03:31 PM	#2
Accord Man THE GENERAL Join Date: Aug 2001 Location: Earth (usually) Age: 43 Posts: 5,698	Hello fellow Canadian! When you get sounds at low speed, cornering.. bla bla It's probably time to replace the bearings.. The balls are probably all crushed. __________________ HondaStyle.com Babysitter's Club Member #0 Soon to be >Dr Max Immuh<

12-28-2001, 06:38 PM	#3
ebpda9 Repost Wagon Join Date: Dec 2001 Location: over here Age: 45 Posts: 17,266	change those damn bearings and it will go away. I had it on my accord and they dissapeared after a while, but i'm expecting them soon. __________________

01-04-2002, 10:01 AM	#5
ebpda9 Repost Wagon Join Date: Dec 2001 Location: over here Age: 45 Posts: 17,266	Yep it's true. __________________

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

01-02-2002, 01:31 PM	#4
twoglude Posts: n/a	thanx guys. i will do the shafts for sure and most likely the bearings too. i have heard that you have to get the bearings pressed in. is this true?