.:HSTuners::::Hondas Wanted:: |
![]() |
#1 |
Posts: n/a
|
Speedo calibration using "yellow box"
I posted in H-T asking how do I change my speedo's calibration. They referred me to this site, Black Robotics, and that was pretty much all the help they would give me.
I am going to get this yellow box, which simply splices into the speedo signal wire. My problem is that I am unsure how to find the speedo signal wire. My Chilton's is absolutely no help, and I haven't found anything about it on the internet. How do I figure out which one carries the signal? |
![]() |
![]() |
#2 |
Yahoo Watashi wa kattaze!
Join Date: May 2002
Location: Meanwhile, up in The D...
Age: 41
Posts: 10,579
|
ok, here's the section of the wiring diagram from helms
on the left the 2 wires that lead off the page from the vss: top (a)- leads to the charging system bottom (b) leads to the dimming circuit ![]() if the image is too small for you to read the words click here |
![]() |
![]() |
![]() |
Thread Tools | |
Display Modes | |
|
|