.:HSTuners::

08-31-2003, 04:13 PM

Putting a tach into my civic... 97 HB DX. Its a small 2" one, we can get everything to work except the RPM's, it lights up it powers on, all that good stuff. The wire we tapped into for rpms "green one" was in the back of my cluster it is a blue with black stripe wire... Is this correct? Any easier thoguhts? THANKS

ebpda9 · 08-31-2003, 05:43 PM

i thought you usually have to connect it to the positive wire of the coil, which has more like a sinusoidal signal, not a square type signal like the usual clusters have. well i hope i know what i am talking about lol

08-31-2003, 04:13 PM	#1
Notyab Posts: n/a	Help with Tach install! Putting a tach into my civic... 97 HB DX. Its a small 2" one, we can get everything to work except the RPM's, it lights up it powers on, all that good stuff. The wire we tapped into for rpms "green one" was in the back of my cluster it is a blue with black stripe wire... Is this correct? Any easier thoguhts? THANKS

08-31-2003, 05:43 PM	#2
ebpda9 Repost Wagon Join Date: Dec 2001 Location: over here Age: 44 Posts: 17,266	i thought you usually have to connect it to the positive wire of the coil, which has more like a sinusoidal signal, not a square type signal like the usual clusters have. well i hope i know what i am talking about lol __________________

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode