.:HSTuners::::Hondas Wanted:: |
04-27-2003, 07:53 PM
|
#1 |
|
Posts: n/a
|
Throttle body size...
For a turbo b18c1, whwat size throttle body should i get?
|
|
|
04-28-2003, 12:26 PM
|
#2 |
|
1st Gear
Join Date: Dec 2002
Location: Illinois
Age: 45
Posts: 74
|
70mm would be best...
__________________
Suja 1 Motoring 502 E St. Charles Carol Stream, IL 60188 630-407-0711 www.suja1.com AIM:Jazn671 |
|
|
|
04-28-2003, 08:52 PM
|
#3 | |
|
Posts: n/a
|
Quote:
well, if its too big, then i'll lose back pressure and that means i lose low end torque....so are you sure a 70mm would be best for a turbo b18c1? |
|
|
|
|
04-30-2003, 09:05 PM
|
#4 | |
|
Moderator
Join Date: Feb 2002
Location: Az
Age: 44
Posts: 3,804
|
Quote:
You'll lose velocity not backpressure, but with a small fast spooling turbo it wouldnt matter too much anyway. I wouldnt even bother switching it out. |
|
|
|
|
|
05-03-2003, 09:03 AM
|
#5 |
|
1st Gear
Join Date: Dec 2002
Location: Illinois
Age: 45
Posts: 74
|
too big? i'd say it's too big for factory compression for a naturally aspirated honda but for a turbocharged honda, you'd want a 70mm throttle body streetable... you'd see up to 85 mm on 25+psi drag hondas...
__________________
Suja 1 Motoring 502 E St. Charles Carol Stream, IL 60188 630-407-0711 www.suja1.com AIM:Jazn671 |
|
|
|
|
05-03-2003, 10:51 AM
|
#6 | |
|
Posts: n/a
|
Quote:
i see...thanks. |
|
|
|
|
05-04-2003, 09:23 PM
|
#7 |
|
Posts: n/a
|
I make quite a bit on a 65mm and it revs to 10.5K. If you want more Edelbrock will release a 70 and 75mm with an adapter in June
|
|
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
