.:HSTuners::::Hondas Wanted:: |
03-05-2004, 07:33 AM | #1 |
Posts: n/a
|
please please please help!
I have a 96 honda accord lx nonvtec with a TEC distributor. In this picture
http://www.hondaautomotiveparts.com/...UTOR+%28TEC%29 where can i find 11 the coil in my distributor? Also On the distributor houseing how do i get that triangle looking thing off, i tried taking off the 3 screws no luck. |
03-05-2004, 07:46 AM | #2 |
Repost Wagon
Join Date: Dec 2001
Location: over here
Age: 43
Posts: 17,266
|
try the honda dealer, or you could go with a an external coil conversion kit, and an external coil. i can get you those. what makes you think the coil is bad ?
__________________
|
03-06-2004, 09:45 AM | #3 |
Posts: n/a
|
hey man
my coil is not bad im doing an accel external coil conversion kit. But I installed the system but heres the problem i have an external coil which i just found out, and no instrcutions on how to hook the wires up on it. So i tried going through my haynes manual and tried to hook it up what i thought the power wire and signal wire was but no luck. So heres my question with this kit what happnes to the stock external coil? Theres a plug with 3 wires that gors to it and then the coil wire goes to my distributor cap. well if this kit make the coil wire go to its external coil then what happens to the stock coil with the 3 wires connected to it?
|
03-06-2004, 02:20 PM | #4 |
Repost Wagon
Join Date: Dec 2001
Location: over here
Age: 43
Posts: 17,266
|
on my msd 2 of the wires connected to the same wire on the amplifier, then the output had only 2 wires that connected to the msd coil, and the canter wire went to the cap. i can scan the instructions later on.
__________________
|
03-07-2004, 12:20 AM | #5 |
Posts: n/a
|
hey man i appreciate your help your the only one thats helping, so i appreciate it but I just need to know in my distributor wheres my trigger wire and power wire, and ill be good, the haynes manual does not tell me. but on my accel system its suppose to plug up wiht mid to existing wire harnesses.
|
03-07-2004, 01:54 AM | #6 |
Repost Wagon
Join Date: Dec 2001
Location: over here
Age: 43
Posts: 17,266
|
ok here is what i managed to pull out of mitchell:
Blue wire--rpm output signal Yellow/Green--Ignition input signal Black/yelloow-Ignition Green--primary output control i hope this helps you a bit.
__________________
|
Thread Tools | |
Display Modes | |
|
|