.:HSTuners::

02-06-2004, 11:50 AM

Just got my JDMShit CF Duckbill wing but it didn't come with any screws? Anyone know what to get for this? Also, should I just cut thew wires going to the rear wiper and the 3rd taillight? Its for a 94 Hatch....Thanx!

02-06-2004, 10:08 PM

to my knowledge I thought it was attached along the underside of the hatch by like 4 screws or so..but I could be completely wrong.
As for the third brake light wires I would not cut them as you could have trouble come inspection time..
If you don't use your rear wiper I guess you could cut those wires but I'm sure there is a way around them....good luck.

*pdiggitydogg* · 02-06-2004, 10:33 PM

lift the hatch..Im pretty sure that you'll see the 4 holes (remember I drive ek so this is way back memory from a buddy's car)
dont use wood screws! get some bolts from the hardware.

Its cf so dont make the bolts too tight...it will easily crack if you go too far. Get some thread lock (blue, NOT red) and put a little on each one just incase

I hear those are really nice spoilers, by the way

02-06-2004, 11:50 AM	#1
seze1 Posts: n/a	help with duckbill Just got my JDMShit CF Duckbill wing but it didn't come with any screws? Anyone know what to get for this? Also, should I just cut thew wires going to the rear wiper and the 3rd taillight? Its for a 94 Hatch....Thanx!

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

02-06-2004, 10:08 PM	#2
4drmadness Posts: n/a	to my knowledge I thought it was attached along the underside of the hatch by like 4 screws or so..but I could be completely wrong. As for the third brake light wires I would not cut them as you could have trouble come inspection time.. If you don't use your rear wiper I guess you could cut those wires but I'm sure there is a way around them....good luck.

02-06-2004, 10:33 PM	#3
pdiggitydogg Yahoo Watashi wa kattaze! Join Date: May 2002 Location: Meanwhile, up in The D... Age: 40 Posts: 10,579	lift the hatch..Im pretty sure that you'll see the 4 holes (remember I drive ek so this is way back memory from a buddy's car) dont use wood screws! get some bolts from the hardware. Its cf so dont make the bolts too tight...it will easily crack if you go too far. Get some thread lock (blue, NOT red) and put a little on each one just incase I hear those are really nice spoilers, by the way