.:HSTuners::

10-03-2003, 01:20 PM

see im looking to be a little different by using the piller guage holders and molding them into my dash becauze my dash has adrop section that i normally throw my change on but since i had thought of molding theguage piller into it instead i just thought id ask if anyone had doneit before so that way i wouldknow on the difficultyrating so i would know about how long it will take me to do the job formy car.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

10-03-2003, 01:20 PM	#4
nosaj81_2000 Posts: n/a	see im looking to be a little different by using the piller guage holders and molding them into my dash becauze my dash has adrop section that i normally throw my change on but since i had thought of molding theguage piller into it instead i just thought id ask if anyone had doneit before so that way i wouldknow on the difficultyrating so i would know about how long it will take me to do the job formy car.