View Single Post
Old 10-31-2004, 11:48 AM   #4
ebpda9
Repost Wagon
 
ebpda9's Avatar
 
Join Date: Dec 2001
Location: over here
Age: 43
Posts: 17,266
Skunk 2 Camber kit.
Vehicly installed on: 2000 honda civic ex-coupe

Type: control arm with sliding balljoint

This kit wasn't installed on any of my cars, but it was a very easy kit to install. it went straight in and required very little tinkering with it to have it installed (provided that your old control arm is not a PITA to take off). Also it offers a great range of adjustament form -4 to +4 degrees as per manufacturer's specs. I haven't heard any complaints about it so far, except one that the first generation of this camber kit would get loose balljoints after 1 year. Also the interference with the inwr fender was almost inexistent (unless your car is dropped 3" or more then you might bottom out). it's a very good kit for the money.

Ease of installation: 2
Durability: 8
Overall: 9
__________________


ebpda9 is offline   Reply With Quote