i would buy the acura rebuild kit. i like oem parts over autozone...
valve jobs is cutting the valve seat. 3 angle = cut at 3 different angles, 5 angle = cut at 5 different angles. 5 is custom and normally you'll have to provide specs or degrees at which you wish cut. 3 angle's pretty standard and most machine shops use that standard. since this sounds like a budget boost build, i'd run a block guard and low compression head gasket.
__________________
Suja 1 Motoring
502 E St. Charles
Carol Stream, IL 60188
630-407-0711
www.suja1.com
AIM:Jazn671
|