HSTuners - View Single Post

12-21-2002, 07:03 PM

I just recently purchased a jdm H22a. I am looking to build the motor and then turbo it. But I would like to increase the displacement. I plan on resleeving the motor, and bore the cylinders to .030 over or .060 or maybe more. But too what extent can i take this to? I am also looking to increases the stroke. But I am unfamiliar on how to do so. Should I buy longer rods? Do I have to buy a new performance crank? Or should I do both. In doing so, after this is all said an done what are my rev limitations going to be? Will I be able to rev the motor higher or lower? How much can i expect the displacement to increase?Please help!!

12-21-2002, 07:03 PM	#1
maxfli7677 Posts: n/a	Increaseing displacement ????? I just recently purchased a jdm H22a. I am looking to build the motor and then turbo it. But I would like to increase the displacement. I plan on resleeving the motor, and bore the cylinders to .030 over or .060 or maybe more. But too what extent can i take this to? I am also looking to increases the stroke. But I am unfamiliar on how to do so. Should I buy longer rods? Do I have to buy a new performance crank? Or should I do both. In doing so, after this is all said an done what are my rev limitations going to be? Will I be able to rev the motor higher or lower? How much can i expect the displacement to increase?Please help!!